Wago PFC200: KNX module

Begonnen von domocla, 14. September 2017, 19:01:18

Vorheriges Thema - Nächstes Thema

0 Mitglieder und 1 Gast betrachten dieses Thema.

domocla

Hi there,
I am working on integrattion of KNX bus with a Wago PFC200. All the procedure is clear but I need a to clearify a doubt.

In case I would like to send always a bit telegram value a "0" and not a toggle how can do that? In the FB for a switch there is only a xSwitch_IN. If there's a rising edge of the signal wago send a "1" in KNX system and it send "0" when the signal goes low.

But I would like send always "0" to KNX bus. Could you help me please?

Thanks.

Maxeyejoe

A good website and then make up the majority of visitors come here specially.