Beiträge

Hi there,
I am working on integrattion of KNX bus with a Wago PFC200. All the procedure is clear but I need a to clearify a doubt.

In case I would like to send always a bit telegram value a "0" and not a toggle how can do that? In the FB for a switch there is only a xSwitch_IN. If there's a rising edge of the signal wago send a "1" in KNX system and it send "0" when the signal goes low.

But I would like send always "0" to KNX bus. Could you help me please?

Thanks.

Dear All,
I write in English because my deutch is very bad.

I would like to send url message or http commands from a client (browser tablet, PC or smartphone) to a PLC Wago which I would like set as server. This to command PLC action from an external web site or device.

What do you suggest please?

Thanks.